Ford Mustang (1999-2004) Service Manual: Battery and Charging System
- Charging System - General Information
- Battery, Mounting and Cables
- Battery and Cables
- Battery (Diagnosis and Testing)
- Battery Disconnect
- Battery (Removal and Installation)
- Battery Tray
- Battery Cables
- Generator and Regulator
Switch - Key-In-Ignition Warning
Removal
1. Remove the ignition switch lock cylinder.
1. Insert the ignition key and turn to the RUN position.
2. Insert a punch in the access hole of the steering column and
press the ...
Charging System - General Information
General Specifications
...
Other materials:
Installation
1. NOTE: LH shown; RH similar.
Install the camshafts.
Lubricate the camshafts with clean engine oil.
2. Install the camshaft bearing cap assemblies and tighten the bolts in the
sequence shown.
3. Install the bolts.
4. CAUTION: Timing marks must be a ...
Bearings - Inspection
NOTE: If any of the following conditions exist, install a new
bearing.
1. Inspect the bearing for a bent cage.
2. Inspect bearings for galling (metal smears on roller ends).
Galling is caused by overheating, poor lubrication or an overload
situatio ...
Special Operating Condition Requirements
When towing a trailer or using a camper or car-top carrier:
Change engine oil and install a new oil filter every 4,800 km (3,000
miles) or 3 months.
Change transfer case fluid every 96,000 km (60,000 miles).
Change manual transmission fluid as required.
...
