Ford Mustang (1999-2004) Service Manual: Water Bypass Hose - 3.8L
Removal and Installation
1. Drain the engine coolant. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.
2. Remove the bypass hose.
3. To install, reverse the removal procedure.
4. Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.
Cooling Fan Motor and Shroud
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the degas bottle or coolant expansion tank. For additional
information, refer to Degas
Bottle-4.6L(2V) and 4.6L(4V) in this ...
Degas Bottle - 4.6L(2V) and 4.6L(4V)
Removal and Installation
1. Drain the engine coolant from the degas bottle only. For additional
information, refer to Cooling
System Draining, Filling and Bleeding in this section.
2. Disconnect the ...
Other materials:
Bearings - Inspection
NOTE: If any of the following conditions exist, install a new
bearing.
1. Inspect the bearing for a bent cage.
2. Inspect bearings for galling (metal smears on roller ends).
Galling is caused by overheating, poor lubrication or an overload
situatio ...
Valve Seals
Special Tool(s)
Valve Spring Compressor
303-452 (T93P-6565-AR)
Valve Stem Seal Replacer
303-383 (T91P-6571-A)
Compressor, Valve Spring
(Exhaust)
303-567 (T97P- 6565-AH)
Material
Item
Specification
Supe ...
Tracing Powder
Tracing powder is used to check both the uniformity of contact and the
tension of a seal against its
sealing surface. These tests are usually done when a suspected air leak/noise
appears to originate
from the seal area or during the alignment and adjustment ...
