Ford Mustang (1999-2004) Service Manual: Service Information
- Identification Codes
- Vehicle Identification Number (VIN) Locator
- Vehicle Certification (VC) Label Locator
- Paint Codes
- Interior Trim Codes
- Spring Codes
- Unique Calibration
- Jacking and Lifting
- Maintenance Schedule
- General Maintenance Information
- Special Operating Condition Requirements
- Checks and Services
- Normal Schedule
- Exceptions To Normal Schedule
- Noise, Vibration and Harshness
- Noise, Vibration and Harshness (NVH) (Description and Operation)
- Electronic Vibration Analyzer (EVA)
- Vibrate Software
- Tracing Powder
- Index Card
- Noise, Vibration and Harshness (NVH) (Diagnosis and Testing)
- Tire Wear Chart
- Brake Disc Machining
- Powertrain/Drivetrain Mount Neutralizing
- Exhaust System Neutralizing
- Wheel Bearing Check
Other materials:
Evaporator Core Housing
Material
Item
Specification
PAG Compressor Oil (R-134a
Systems)
F7AZ-19589-DA (Motorcraft
YN-12-C)
WSH-M1C231-
B
MERPOL
NA
ESE-M99B144-
B
Removal
NOTE: The evaporator core is not separately serviceable, it is
serviced onl ...
Piston - Pin Diameter
1. Measure the piston pin diameter in two directions at the points shown.
Verify the diameter is
within specification.
Refer to the appropriate section in Group for the procedure.
If out of specification, install new components as necessary. Refer
...
Transmission Electronic Control System
The powertrain control module (PCM) and its input/output network
control the following transmission
operations:
Shift timing
Line pressure (shift feel)
Torque converter clutch
The transmission control is separate from the engine control s ...


