Ford Mustang (1999-2004) Service Manual: Air Cleaner Outlet Pipe - 4.6L (4V)

Removal and Installation

Cobra

1. Disconnect the intake air temperature (IAT) sensor.

Cobra

All vehicles

2. Disconnect the vacuum hose.

All vehicles

3. Disconnect the breather hose.

All vehicles

NOTE: Cobra shown, Mach I similar.

4. Loosen the clamps and remove the air cleaner outlet pipe.

All vehicles

5. To install, reverse the removal procedure.

    Air Cleaner Outlet Pipe - 3.8L
    Removal and Installation 1. Remove the air cleaner outlet tube. 1. Loosen the clamps. 2. Disconnect the hose. 3. Remove the tube. 2. To install, reverse the removal procedure. Air Clea ...

    Air Cleaner - 3.8L
    Removal and Installation 1. Remove the air cleaner outlet tube from the throttle body. For additional information, refer to Air Cleaner Outlet Pipe-3.8L in this section. 2. Disconnect the connec ...

    Other materials:

    Component Tests
    Ball Joint Inspection 1. Raise and support the vehicle. 2. Prior to performing any inspection of the ball joints, inspect the wheel bearings. 3. Position a safety stand beneath the front suspension lower arm (3079) to be tested. 4. While an assistant pul ...

    Driveshaft - Cobra
    Material Item Specification Threadlock and Sealer E0AZ-19554-AA WSK-M2G351-A5 (type II) Silicone Lubricant (Aerosol) F5AZ-19553-AA ESR-M13P4-A Removal and Installation 1. Raise and support the vehicle. 2. NOTE: To aid disass ...

    Analysis of Vibration
    WARNING: A vehicle equipped with a Traction-Lok differential will always have both wheels driving. If only one wheel is raised off the floor and the rear axle is driven by the engine, the wheel on the floor could drive the vehicle off the stand or jack. Be s ...