Ford Mustang (1999-2004) Service Manual: Engine Support Insulators

Crankshaft Rear Seal

Special Tool(s) Impact Slide Hammer 100-001 (T50T-100-A) Remover, Crankshaft Rear Seal 303-519 (T95P-6701-EH) Replacer, Rear Crankshaft Seal 303-516 (T95P- ...

Removal

1. Disconnect the battery ground cable (14301). 2. Remove the air cleaner outlet tube (9B659). 3. Remove the radiator sight shield (8C291). 4. Remove the coolant recovery reservoir (8A080). ...

Other materials:

Exterior Trim and Ornamentation
Torque Specifications Exterior Trim and Ornamentation The exterior trim and ornamentation consists of the following components: body side scoop hood scoop (if equipped) front spoiler (Mach 1) radiator grille rear spoiler (if equipped) ...

Shock Absorber
Removal WARNING: All vehicles are equipped with gas pressurized shock absorbers which will extend unassisted. Do not apply heat or flame to the shock absorbers during removal or component servicing. Failure to follow these instructions can result in personal ...

Installation
1. NOTE: The LH side is shown, and the RH is similar. Install the supply manifold and tighten the four bolts. 2. Connect the EGR vacuum line. 3. Install the EGR to exhaust manifold tube. For additional information, refer to Section. 4. NOTE: The eng ...