Ford Mustang (2005-2014) Owners Manual: Bulb specification chart

Replacement bulbs are specified in the chart below. Headlamp bulbs must be marked with an authorized D.O.T. for North America and an E for Europe to ensure lamp performance, light brightness and pattern and safe visibility. The correct bulbs will not damage the lamp assembly or void the lamp assembly warranty and will provide quality bulb burn time.

    Changing a bulb
    Lamp Assembly Condensation Exterior lamps are vented to accommodate normal changes in pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly throug ...

    Vehicle Care
    GENERAL INFORMATION Your Ford or Lincoln authorized dealer has many quality products available to clean your vehicle and protect its finishes. ...

    Other materials:

    Engine Dynamic Balance Shaft
    Removal 1. Remove the timing chain (6268). For additional information, refer to Timing Chain in this section. 2. Disconnect and position the wire harness aside. 3. Remove the radiator fan and shroud assembly (8146). 4. Remove the engine dynamic balan ...

    Pedal and Bracket
    Removal 1. Disconnect the battery ground cable (14301). 2. Remove the stoplight switch retaining pin. 3. Slide the stoplight switch (13480) and booster push rod from the brake pedal pin. 4. Remove the brake pedal bracket retaining bolt. 5. Remove the ...

    Bearing Whine
    Bearing whine is a high-pitched sound similar to a whistle. It is usually caused by worn/damaged pinion bearings, which are operating at driveshaft speed. Bearing noise occurs at all driving speeds. This distinguishes it from gear whine which usually comes ...