Ford Mustang (1999-2004) Service Manual: Exhaust Manifold RH

Removal and Installation

1. Disconnect the battery ground cable. For additional information, refer to Section.

2. Raise the vehicle. For additional information, refer to Section.

3. Remove the dual converter Y-pipe. For additional information, refer to Section.

4. Remove the starter. For additional information, refer to Section.

5. Remove the exhaust manifold.

1. Remove the nuts.

2. Remove the exhaust manifold.

3. Remove and discard the gasket.

Exhaust Manifold RH

6. To install, reverse the removal procedure.

  • Use a new exhaust manifold gasket.
  • Tighten the exhaust manifold nuts in the sequence shown.

Exhaust Manifold RH

    Installation
    1. NOTE: LH shown; RH similar. Install the camshafts. Lubricate the camshafts with clean engine oil. 2. Install the camshaft bearing cap assemblies and tighten the bolts in the sequence shown. ...

    Exhaust Manifold LH
    Removal and Installation 1. Position the steering wheel straight ahead and lock the column. 2. Disconnect the battery ground cable. For additional information, refer to Section. 3. Raise the vehicl ...

    Other materials:

    Caliper (Disassembly and Assembly)
    Special Tool(s) Rear Caliper Piston Adjuster 206-026 (T87P-2588-A) Rear Caliper Spring Compressor Set 206-S027 (T87P-2588-B) Disassembly 1. Remove the rear disc brake caliper (2552). For additional information, refer to Caliper i ...

    Clutch Pedal - Quadrant and Pawl Assembly
    Removal 1. Disconnect the battery ground cable (14301). 2. Loosen the nut from inside the engine compartment. 3. Loosen the nuts from inside the vehicle. 4. Loosen the screw. 5. Disconnect the brake pedal position (BPP) switch electrical connector. ...

    Tracing Powder
    Tracing powder is used to check both the uniformity of contact and the tension of a seal against its sealing surface. These tests are usually done when a suspected air leak/noise appears to originate from the seal area or during the alignment and adjustment ...