Ford Mustang (1999-2004) Service Manual: Flexplate

Removal and Installation

1. Remove the transmission.

2. Remove the six bolts retaining the flexplate to crankshaft, and remove the flexplate.

Flexplate

3. To install, reverse the removal procedure.

    Oil Pump Screen and Pickup Tube
    Removal and Installation 1. Remove the oil pan (6675). For additional information, refer to Oil Pan in this section. 2. Remove the oil pump screen cover and tube (6622) and discard the gasket. ...

    Crankshaft Rear Seal
    Special Tool(s) Impact Slide Hammer 100-001 (T50T-100-A) Remover, Crankshaft Rear Seal 303-519 (T95P-6701-EH) Replacer, Rear Crankshaft Seal 303-516 (T95P- ...

    Other materials:

    Input Shaft and Bearing
    Special Tool(s) Remover, Driver Pinion Bearing Cone 205-D002 (D79L-4621-A) or equivalent Installer, Drive Pinion Bearing Cone 205-011 (T57L-4621-B) Remover/Installer, Bearing Tube 308-024 (T75L-7025-B) Disas ...

    Engine (Removal)
    Special Tool(s) Lifting Bracket, Engine 303-D087 (D93P-6001-A1) Lifting Bracket, Engine 303-D088 (D93P-6001-A2) Spreader Bar 303-D089 (D93P-6001-A3) Removal All vehicles 1. Disconnect the battery ground cable. Fo ...

    Mass Air Flow (MAF) Sensor - Mach I
    Removal CAUTION: The mass air flow (MAF) sensor hot wire sensing element and housing are calibrated as a unit and must be repaired as a complete assembly. Do not damage the sensing element (internal to housing) or possible failure to the mass air f ...