Ford Mustang (1999-2004) Service Manual: Installation

1. Install the bearing.

1. Position the knuckle on the press.

2. Using the appropriate step plate adapter, press the bearing into the knuckle until the bearing clears the snap ring groove and bottoms out in the bore.

Wheel Hub - Cobra

2. Install the snap ring.

Wheel Hub - Cobra

3. CAUTION: The bearing inner race must be supported during hub installation.

Failure to follow these instructions can damage the bearing.

Install the hub.

1. Position the knuckle in a press, making sure the wheel bearing inner race is supported with the appropriate step plate adapter.

2. Using the special tool, install the hub.

Wheel Hub - Cobra

4. Install the dust shield and new bolts.

Wheel Hub - Cobra

5. Inspect the bearing dust seal. If necessary, install a new dust seal.

Wheel Hub - Cobra

6. Using a hammer and chisel, remove the dust seal.

Wheel Hub - Cobra

7. Using the special tools, install the dust seal.

Wheel Hub - Cobra

8. Install the knuckle. For additional information, refer to Wheel Knuckle-Cobra in this section.

    Removal
    CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part ...

    Wheel Studs
    Special Tool(s) C-Frame and Clamp Assembly 211-023 (T74P-3044-A1) Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and syst ...

    Other materials:

    Installation
    1. Inspect the rear axle pinion flange seal journal for rust, nicks, and scratches prior to installing the flange. Polish the seal journal with fine crocus cloth, if necessary. 2. Lubricate the rear axle pinion flange splines. Use SAE 75W-140 High Performa ...

    Inspection and Verification
    1. The keyless entry system is a generic electronic module (GEM). 2. Verify the customer concern by using the remote transmitters to operate the keyless entry system. 3. Visually inspect for the following obvious signs of mechanical and electrica ...

    Battery Tray
    Removal and Installation WARNING: Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted substances to come near the battery. When charging or working near a battery, always sh ...