Ford Mustang (1999-2004) Service Manual: Instrumentation and Warning Systems
- Instrument Cluster and Panel Illumination
- Instrument Cluster and Panel Illumination (Diagnosis and Testing)
- Instrument Cluster (Description and Operation)
- Instrument Cluster (Diagnosis and Testing)
- Instrument Cluster
- Horn
- Warning Devices
Vacuum Control Motor - Air Damper Door
Removal
1. Remove the instrument panel. For additional information, refer to Section.
2. Disconnect the vacuum hose.
3. Remove the vacuum control motor.
1. Remove the steel clip.
2. Loosen the n ...
Instrument Cluster and Panel Illumination
The instrument cluster and panel illumination system illuminates the
following components:
instrument cluster (10849)
audio unit (18806)
A/C-heater control
fog lamp switch
transmission range in ...
Other materials:
Accelerator Cable Bracket - 4.6L (2V)
Removal and Installation
1. Disconnect the speed control cable from the throttle body and the bracket.
For additional
information, refer to Section.
2. Disconnect the accelerator cable from the throttle body by rotating the
throttle body full open
and align ...
Piston - Pin Diameter
1. Measure the piston pin diameter in two directions at the points shown.
Verify the diameter is
within specification.
Refer to the appropriate section in Group for the procedure.
If out of specification, install new components as necessary. Refer
...
Installation
1. Inspect the pinion flange seal journal for rust, nicks, and scratches
prior to installing the flange.
Polish the seal journal with fine crocus cloth, if necessary.
2. Lubricate the pinion flange splines.
Use SAE 80W-90 Premium Rear Axle Lubricant XY-80 ...
