Ford Mustang (1999-2004) Service Manual: Removal
1. Remove the rear defrost connectors if necessary.
2. Remove the nuts retaining the well sling and convertible top tacking strips.
3. Remove the three tacking strips.
4. Mark the top of the convertible top skin around the top of all three tacking strips with a grease pencil.
5. Remove the visible staples.
6. Remove the water diverter.
7. Mark the winter seal at the top, bottom and the forward edge of the rear tacking strip.
8. Remove the winter seal.
9. Lift the rear cover assembly over the convertible top exposing the top of the rear window glass assembly.
10. Remove all of the staples in the cover assembly along the number four bow.
11. Remove all of the staples in the rear window glass assembly along the number four bow.
12. Remove the rear window glass assembly.
Installation
1. Overlay the new rear window glass assembly over the old rear
window glass assembly and
transpose the markings with a grease pencil.
2. Center the V-notch on the new rear window glass assemb ...
Other materials:
Lamp Assembly - Fog Lamp (GT)
Removal
1. Raise and support the vehicle.
2. Remove the screw.
3. Partially lower the vehicle and remove the fog lamp assembly.
1. Disconnect the electrical connector.
2. Remove the two screws.
3. Remove the fog lamp assembly and replace the bul ...
Mass Air Flow (MAF) Sensor - Cobra
Removal and Installation
1. Disconnect the intake air temperature (IAT) sensor.
2. Disconnect the breather hose.
3. Disconnect the vacuum hose.
4. Loosen the clamps and remove the air cleaner outlet pipe.
5. CAUTION: The mass air flow (MAF) sensor ho ...
Brake Caliper Support Bracket
Removal
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. CAUTION: Do not allow the rear disc brake caliper (2552) to
hang from the rear
wheel brake hose (2A442)
Remove the rear disc brake caliper bolts and position the ...
