Ford Mustang (1999-2004) Service Manual: Seal

Special Tool(s)

Installer, Transmission Extension Housing Oil Seal 308-227 (T94P-7657-A)
Slide Hammer 100-001 (T50T-100-A)
Remover, Bushing 307-001 (TOOL-1175-AC) or Equivalent

Removal

1. With the vehicle in NEUTRAL, raise and support the vehicle.

2. CAUTION: Index-mark the driveshaft flange and pinion flange, and the driveshaft slip yoke and transmission output shaft.

Remove the driveshaft. For additional information, refer to Section.

3. Using the special tools, remove the extension housing fluid seal.

Seal

Installation

1. Using the special tool, install the extension housing fluid seal.

Seal

2. CAUTION: Align the index marks.

Install the driveshaft. For additional information, refer to Section.

3. Check the transmission fluid level, add fluid if necessary.

4. Lower the vehicle.

    Bearings - Inspection
    NOTE: If any of the following conditions exist, install a new bearing. 1. Inspect the bearing for a bent cage. 2. Inspect bearings for galling (metal smears on roller ends). Galling is caused ...

    Other materials:

    Driveline System - General Information
    Driveline Angles @ Curb Specifications All driveshaft and pinion angles point downward. General Specifications a: Service refill capacities are determined by filling the axle 6.3 mm (0.25 in [1/4 in]) to 14.3 mm (0.57 in [5/16 in]) below the bottom of the ...

    Pinpoint Tests
    CAUTION: Before removing and installing the generic electronic module (GEM) or its connectors, disconnect the battery. Failure to follow this caution will result in the GEM storing many erroneous DTCs, and it may exhibit erratic operation after in ...

    Front passenger sensing system
    WARNING: Even with Advanced Restraints Systems, children 12 and under should be properly restrained in a rear seating position. Failure to follow this could seriously increase the risk of injury or death. WARNING: Sitting improperly out of position or with the ...