Ford Mustang (1999-2004) Service Manual: Rocker Arm

Removal

CAUTION: If removing more than one rocker arm (6564), mark the components removed for correct location.

1. Remove the valve covers. For additional information, refer to Valve Cover-LH and Valve Cover RH in this section.

2. Remove the rocker arm assembly.

  • Remove the bolt.

Rocker Arm

Installation

1. Install the rocker arms, tighten the bolts in two stages.

  • Stage 1: tighten to 5 Nm (44-lb-in).
  • Stage 2: tighten to 35 Nm (26 lb-ft).

2. Install the valve covers. For additional information, refer to Valve Cover-LH and Valve Cover RH in this section.

    Installation
    1. CAUTION: In order to prevent foreign material from contaminating the engine block or the engine front cover it is necessary to seal the coolant and oil passages of both components. Failure to ...

    Push Rod
    Removal CAUTION: Mark the components removed for correct location. 1. Remove the rocker arms (6564). For additional information, refer to Rocker Arm in this section. 2. Remove the push rods (656 ...

    Other materials:

    Rear View Mirrors (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 124 , Power Mirrors for schematic and connector information. Special Tool(s) 73III Automotive Meter 105-R0057 or equivalent Flex Probe Kit 105-R025B or equivalent Inspection and Verification 1. ...

    Clutch Controls (Description and Operation)
      The clutch control system engages and disengages the clutch. The clutch control system disengages the clutch when the clutch pedal is depressed and engages the clutch when the clutch pedal is released. Clutch pedal motion is transmitted by the c ...

    Negative and Positive Camber
    Camber is the vertical tilt of the wheel (1007) when viewed from the front. Camber can be positive or negative and has a direct effect on tire wear. Caster Item Part Number Description 1 - Positive caster 2 - True vertical ...