Ford Mustang (1999-2004) Service Manual: Safety Belt System
Torque Specifications
- Safety Belt System (Description and Operation)
- Safety Belt System (Diagnosis and Testing)
- Safety Belt Maintenance
- Safety Belt Tongue Rotated on Belt
- Retractor - Front Seat Safety Belt, Coupe
- Retractor - Front Seat Safety Belt, Convertible
- Retractor - Rear Seat Safety Belt, Coupe
- Retractor - Rear Seat Safety Belt, Convertible
- Child Safety Seat Belt - Tether Anchor
- Safety Belt Buckle - Front Seat
- Safety Belt Buckle - Rear Seat
Rear Bumper
Removal and Installation
All vehicles
1. Remove the rear bumper cover. For additional information, refer to Rear
Bumper Cover in this
section.
2. Remove the rear bumper cover isolator.
Vehicles with ...
Safety Belt System (Description and Operation)
WARNING: All safety belt assemblies include retractors, buckles, front
seat belt buckle
support assemblies (slide bar, if so equipped), shoulder belt height adjuster
(if equipped), child
safety seat ...
Other materials:
Removal
1. Remove the rear exterior trim mouldings.
2. Remove the clips
3. Remove the 13 Torx screws and the seal compression panel.
4. Remove the staples.
5. Remove the staples from the number one bow.
6. Remove the rear rail weatherstrip retainers from ea ...
Installation
1. NOTE: This procedure applies to both the LH and RH halfshafts.
Install a new driveshaft bearing retainer circlip.
2. Remove the special tool.
3. CAUTION: Differential seal damage will occur if installing the
halfshaft without the
special tool installed. ...
Knob
Removal
1. Remove the shifter top control panel.
2. Disconnect the electrical connectors.
3. Remove the shifter bezel.
4. Remove the bulb from the bezel.
5. Disconnect the TCS connector.
6. CAUTION: Extra force may be needed to lift up on the handle. Do ...
