Ford Mustang (1999-2004) Service Manual: Speed Control
Torque Specifications

Speed Control
The speed control system consists of the following components:
- speed control actuator cable (9A825)
- deactivator switch
- output shaft sensor (OSS)
- speed control actuator switches (9C888)
- brake pedal position (BPP) switch (13480)
- speed control servo (9C735)
- clutch pedal position switch (manual transmission only)
- Speed Control (Diagnosis and Testing)
- Actuator Cable - Speed Control
- Actuator Cable - Speed Control-Cobra
- Actuator - Speed Control Servo
- Switch - Deactivator
- Switch - Speed Control Actuator
Accelerator Cable Bracket - Supercharged Engine
Removal and Installation
1. Disconnect the accelerator cable and speed control cable.
2. Depress the tabs and disconnect the accelerator cable and speed control
cable from the
accelerator cable bra ...
Speed Control (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 31 , Speed Control for schematic and connector
information.
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Test ...
Other materials:
Valve Tappets
Material
Removal
CAUTION: If removing more than one valve tappet, mark the
components removed for
correct location.
1. Remove the lower intake manifold. For additional information, refer to
Lower Intake Manifold in
this section.
2. Remove the push r ...
Assembly
1. CAUTION: 118 ml (4 oz) of the specified Ford Friction Modifier must
be used in the
axle.
Lubricate each steel clutch plate and soak all friction plates for no less than
15 minutes.
Use Additive Friction Modifier C8AZ-19B546-A or equivalent meeting Ford ...
Input Shaft and Bearing
Special Tool(s)
Remover, Driver Pinion
Bearing Cone
205-D002 (D79L-4621-A) or
equivalent
Installer, Drive Pinion Bearing
Cone
205-011 (T57L-4621-B)
Remover/Installer, Bearing
Tube
308-024 (T75L-7025-B)
Disas ...
