Ford Mustang (1999-2004) Service Manual: Steering Column
General Specifications

Torque Specifications

- Steering Column (Description and Operation)
- Ignition Switch Lock Cylinder - Functional
- Ignition Switch Lock Cylinder - Non-Functional
- Wheel
- Column
- Steering Column Shaft
- Coupling
- Steering Column (Disassembly and Assembly)
Assembly
All steering gears
1. Install the steering gear in the special tools.
Steering gears equipped with travel restrictors
2. Install the travel restrictors.
Install new travel restrictors as necessary.
...
Steering Column (Description and Operation)
NOTE: All fasteners are important because they can affect the
performance of vital parts and systems.
Incorrect installation of the fasteners can result in major repair expenses.
They m ...
Other materials:
Dowels - Flywheel Housing to Block
Removal
1. NOTE: Take care not to damage the flywheel housing to block dowel
holes or the surface areas
around the flywheel housing to block dowel hole during removal.
Remove the two flywheel housing to block dowels using a drift pin where the
flywheel ...
Installation
1. CAUTION: To prevent refrigerant system contamination, do not allow
dirt or other
foreign materials to enter the A/C compressor.
Clean the A/C compressor nose area.
2. Place the shaft seal on the special tool. Lubricate the shaft seal and the
special tool ...
Master Cylinder Priming - 4.6L
1. CAUTION: Use only bleed screws on the engine side of the
brake master cylinder
(2140). The hydro-boost bleed screw, located near the dash on the
hydro-booster
casting, is for the booster cavity filled with power steering fluid, not
brake fluid. ...
