Ford Mustang (1999-2004) Service Manual: Toe Link - Cobra

Installation

1. Install the bearing, snap ring, hub and dust shield. For additional information, refer to Wheel Hub-Cobra in this section. 2. Install the knuckle. 1. Position the knuckle on the lower suspensio ...

Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part ...

Other materials:

Axle Housing
Removal and Installation 1. CAUTION: The vehicle must be on level ground and at curb height. Mark the rear shock absorbers relative to their protective sleeve.  During installation, raise the suspension to this reference mark before tightening the s ...

Master Cylinder Priming - 4.6L
1. CAUTION: Use only bleed screws on the engine side of the brake master cylinder (2140). The hydro-boost bleed screw, located near the dash on the hydro-booster casting, is for the booster cavity filled with power steering fluid, not brake fluid. ...

Rear Suspension
Torque Specifications WARNING: All vehicles are equipped with gas pressurized shock absorbers which will extend unassisted. Do not apply heat or flame to the shock absorbers during removal or component servicing. Failure to follow these instructions can re ...