Ford Mustang (1999-2004) Service Manual: Vehicle Identification Number (VIN) Locator
The vehicle identification number (VIN) is a seventeen-digit alphanumeric code. The VIN is stamped on a metal tab riveted to the instrument panel, top upper left of the dash. The VIN number is also found on the vehicle certification (VC) label.
Item | Description |
1 | World manufacturer identifier (WMI) |
2 | Restraint type code |
3 | Line, series, body type (passenger car) |
4 | Engine code |
5 | Computer generated VIN check digit |
6 | Model year code |
7 | Assembly plant code |
8 | Production sequence number |
World Manufacturer Identifier (WMI)
The first three vehicle identification number (VIN) positions are the world manufacturer identifier (WMI).
- 1FA - Ford, USA, passenger car
Restraint Type Code
The fourth VIN position is the vehicle restraint system type code.
- F - Active safety belts - all positions, driver and front passenger air bags
Line, Series and Body Type Code
Positions 5 through 7 indicate vehicle line, series and body type.
- P40 - Two-door coupe
- P42 - Two-door coupe, GT (Mach One available in GT Coupe only)
- P44 - Two-door convertible
- P45 - Two-door convertible, GT
- P48 - Two-door coupe, Cobra
- P49 - Two-door convertible, Cobra
Engine Code
The eighth VIN position is the engine displacement and number of cylinders code.
- 4 - 3.8L, OHV, EFI, six cylinder
- R - 4.6L, DOHC, EFI, eight cylinder (Mach One)
- X - 4.6L, SOHC, EFI, eight cylinder
- Y- 4.6L, DOHC, S/C, EFI, eight cylinder (Cobra)
Computer Generated Check Digit
The ninth VIN position is a government assigned, computer-generated check digit code (0-9).
Model Year Code
The tenth VIN position is the model year code.
- 3 - 2003
Assembly Plant Code
The eleventh VIN position is the assembly plant code.
- F - Dearborn, Michigan (USA)
Production Sequence Number
The last six VIN positions are the production sequence number. This number is also used as the vehicle serial and warranty number.
- 100001-599999
Vehicle Certification (VC) Label
Vehicle Certification (VC) Label Locator
The upper portion of the vehicle certification (VC) label contains the
manufacturer name, the month
and year of manufacture, the certification statement and the VIN. It also
includes gross vehicle ...
Other materials:
Caliper
1. NOTE: It is not necessary to do a complete brake system
bleed if only the disc brake caliper
(2B120) was disconnected.
Place a box end wrench on the disc brake caliper bleeder screw (2208).
Attach a rubber drain
tube to the disc brake caliper b ...
Pinpoint Test M: DTC B1891 - Air Bag Tone Warning Indicator Circuit
Shorted to Battery or
Ignition
Normal Operation
The restraints control module (RCM) monitors its connection to the
generic electronic module (GEM) at
pin 10. This connection is used to signal a chime if the air bag
indicator is inoperative and another SRS
fault exists. If the RC ...
Blower Motor
Removal
1. Disconnect the jumper wire.
2. Disconnect the main harness.
3. Remove the screws.
4. Separate the cover from the motor.
5. Separate the motor from the housing.
6. Disconnect the jumper from the motor.
Remove the blower motor.
Installa ...