Ford Mustang (1999-2004) Service Manual: Blower Motor

Removal

1. Disconnect the jumper wire.

Blower Motor

2. Disconnect the main harness.

Blower Motor

3. Remove the screws.

Blower Motor

4. Separate the cover from the motor.

Blower Motor

5. Separate the motor from the housing.

Blower Motor

6. Disconnect the jumper from the motor.

  • Remove the blower motor.

Blower Motor

Installation

1. To install, reverse the removal procedure.

    Heating and Defrosting
    The heating and defrosting system has the following features: Controls the temperature and, during A/C operation, reduces the relative humidity of the air inside the vehicle. Delivers heated or ...

    Evaporator Core Housing
    Material Item Specification PAG Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN-12-C) WSH-M1C231- B MERPOL NA ESE-M99B144- B Removal NOTE: The evapor ...

    Other materials:

    Hydraulic Brake Actuation (Description and Operation)
      CAUTION: Blistering or swelling of rubber brake components may indicate contamination of the brake fluid by a petroleum based substance. New rubber components must be installed in the hydraulic brake system if contaminated and the entire hydraulic ...

    Door Alignment
    NOTE: The door should be adjusted for even and parallel fit with the body opening and surrounding panels as well as making sure that the anti-chuck pin is not binding on convertible models. 1. Mark the position of the front door hinges to the front ...

    Rear Drive Axle/Differential - Ford 8.8-Inch IRS
    General Specifications Torque Specifications a: Use Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford specification WSKM2G349- A1. b: With pinion flange yoke seal. ...