Ford Mustang (1999-2004) Service Manual: Cylinder Head RH

Material

Cylinder Head RH

Installation
NOTE: Do not use a fiber disc to clean the surfaces. Fibers from the disc can get into the oil pan and oil and clog the oil bypass valve. 1. Clean and inspect the cylinder head for flatness. 2. ...

Removal
1. Disconnect the battery negative cable. 2. Drain the engine cooling system. 3. Remove the RH exhaust manifold. For additional information, refer to Exhaust Manifold RH in this section. 4. Remo ...

Other materials:

Mass Air Flow (MAF) Sensor - 4.6L (2V)
Removal CAUTION: The mass air flow (MAF) sensor hot wire sensing element and housing are calibrated as a unit and must be repaired as a complete assembly. Do not damage the sensing element (internal to housing) or possible failure to the mass air f ...

Engine Ignition (Description and Operation)
The ignition coil (12029), which is mounted on the upper intake manifold, can be described as a coil pack containing three separate coil units. Each coil unit is individually controlled by the powertrain control module (PCM) (12A650) through separate wire le ...

Toe Adjustment - Front
1. Start the engine and center the steering wheel. 2. Turn the engine off, and hold the steering wheel in the straight forward position by attaching a rigid link from the steering wheel to the seat. 3. Check the toe settings. Follow the manufacturer's instr ...