Ford Mustang (1999-2004) Service Manual: Shock Absorber

Removal

WARNING: All vehicles are equipped with gas pressurized shock absorbers which will extend unassisted. Do not apply heat or flame to the shock absorbers during removal or component servicing. Failure to follow these instructions can result in personal injury.

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to ensure proper retention of these parts.

1. Raise the vehicle on a hoist.

2. Remove the wheel and tire assembly.

3. Remove the front brake disc.

4. Remove the bolt and the ABS sensor.

Shock Absorber

5. Unclip the ABS sensor wire from the bracket.

Shock Absorber

6. Remove the nut and the ABS sensor wire bracket.

Shock Absorber

7. Support the front suspension lower arm (3078) with a jack stand.

8. Disconnect the shock absorber (18124) from the spindle (3105).

1. Remove and discard the nuts and bolts.

2. Disconnect the shock absorber.

Shock Absorber

9. Carefully lower the front suspension lower arm and remove the jack stand.

10. CAUTION: Do not allow the weight of the vehicle to rest on the front brake disc shield. Damage to the shield can occur.

Lower the vehicle to access the upper mount nuts and bolt.

11. Remove the shock absorber.

1. Remove the bolt and nuts. Discard the nuts.

2. Remove the shock absorber.

Shock Absorber

12. Position the shock absorber in a vise.

13. Remove the nut and the front shock absorber mounting bracket (18183).

Shock Absorber

14. Remove the sleeve and the bushing.

Installation

1. To install, reverse the removal procedure.

Shock Absorber

 

Shock Absorber

 

Shock Absorber

 

Shock Absorber

 

Shock Absorber

    Spindle
    Special Tool(s) Tie-Rod End Remover 211-001 (TOOL-3290-D) or Equivalent Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and ...

    Spring
    Special Tool(s) Tie-Rod End Remover 211-001 (TOOL-3290-D) or Equivalent Coil Spring Compressor 204-D001 (D78P-5310-A) or Equivalent ...

    Other materials:

    Fuel Injectors
    Removal WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to follow these instructions can result in personal in ...

    Temperature and Manifold Absolute Pressure (T-MAP) Sensor - Cobra
    Removal and Installation 1. Disconnect the temperature manifold absolute pressure (T-MAP) sensor electrical connector. 2. Remove the bolts and the T-MAP sensor. 3. To install, reverse the removal procedure. ...

    Steering Column Switches (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 13 , Power Distribution for schematic and connector information. Refer to Wiring Diagrams Cell 81 , Interval Wiper/Washer for schematic and connector information. Refer to Wiring Diagrams Cell 85 , Headlamps for schematic and co ...