Ford Mustang (1999-2004) Service Manual: Main Control Valve Body

Transmission (DISASSEMBLY)

Special Tool(s) Slide Hammer 100-001 (T50T-100-A) Holding Fixture, Transmission 307-003 (T57L-500-B) Slide Hammer 307-005 (T59L-100-B) Remover, Tra ...

Disassembly

Main Control Valve Body - Disassembled View   1. Remove the torque converter clutch (TCC) solenoid and the shift solenoid. 1. Remove the bolt. 2. Remove the shift solenoid. 3. Remov ...

Other materials:

Wheel Hub or Axle Flange Face Runout
NOTE: If the axle shaft assembly is removed, check runout of the shaft itself. The forged (unmachined) part of the shaft is allowed to have as much as 3.0 mm (0.120 inch) runout. This alone will not cause a vibration condition. 1. Position the special tool ...

Synchronizers
Disassembly and Assembly NOTE: This procedure applies to all synchronizer assemblies. 1. Scribe an alignment mark on the sliding sleeve and the hub for assembly reference. 2. Remove the sliding sleeve, then remove the synchronizer struts and the springs. 3 ...

Brake Shift Interlock Actuator
Removal 1. Remove the shifter top control panel. 2. Disconnect the electrical connectors. 3. Remove the shifter bezel. 4. Remove the bulb from the bezel. 5. Disconnect the electrical connector. 6. CAUTION: Extra force may be needed to lift up on th ...