Ford Mustang (1999-2004) Service Manual: Anti-Lock Control - Rear
Torque Specifications
Anti-Lock Control
The four wheel anti-lock brake system (4WABS) consists of the following components:
- anti-lock brake control module (2C346)
- front anti-lock brake sensor (2C205)
- front anti-lock brake sensor indicator (2C182)
- hydraulic control unit (2C286)
- rear anti-lock brake sensor (2C216)
- rear anti-lock brake sensor indicator (2C189)
- yellow anti-lock brake system (ABS) warning indicator
Brake Booster - Hydro-Boost (Removal and Installation)
Special Tool(s)
Installer Set, Teflon Seal
211-D027 (D90P-3517-A) or
equivalent
Removal
WARNING: The power brake booster should not be carried by the
accumulator, nor
should it e ...
Anti-Lock Control
Refer to Wiring Diagrams Cell 42 , Anti-Lock Brake for schematic and
connector information.
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tes ...
Other materials:
Lumbar Control Switch
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
Vehicles with standard power lumbar
2. Pull to remove the lumbar control switch (14C715).
3. Disconnect the power lum ...
Air Conditioning Line (Peanut) Fitting
Disconnect
1. CAUTION: Support the female fitting with a wrench to prevent the
tubes from
twisting.
Remove the nut from the peanut fitting.
2. Pull the peanut fitting apart.
3. CAUTION: Do not use metal tools to remove the O-ring seal. They can
cause axi ...
Master Cylinder
Removal
1. Disconnect the fluid level sensor connector.
2. Disconnect the brake tubes.
3. Remove the brake master cylinder nuts.
4. Remove the brake master cylinder (2140).
Installation
1. To install, reverse the removal procedure.
Bleed the brake ...
