Ford Mustang (1999-2004) Service Manual: Output Shaft Speed (OSS) Sensor

Removal and Installation

1. With the vehicle in NEUTRAL, raise and support the vehicle.

2. Disconnect the electrical connector.

Output Shaft Speed (OSS) Sensor

3. Remove the output shaft speed (OSS) sensor.

Output Shaft Speed (OSS) Sensor

4. To install, reverse the removal procedure.

    Transmission (Removal)
    1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the gearshift lever knob. 3. Remove the console panel gearshift plate. Lift the gearshift lever boot ...

    Other materials:

    Installation
    1. Inspect the pinion flange seal journal for rust, nicks, and scratches prior to installing the flange. Polish the seal journal with fine crocus cloth, if necessary. 2. Lubricate the pinion flange splines. Use SAE 80W-90 Premium Rear Axle Lubricant XY-80 ...

    Camber Adjustment - Rear
    1. Loosen the nut. 2. Rotate the bolt and the cam to the correct camber setting. 3. Tighten the nut while holding the bolt and the cam stationary. 4. Recheck the wheel alignment. Follow the manufacturer's instructions. Adjust as necessary. ...

    Blower Motor
    Removal 1. Disconnect the jumper wire. 2. Disconnect the main harness. 3. Remove the screws. 4. Separate the cover from the motor. 5. Separate the motor from the housing. 6. Disconnect the jumper from the motor. Remove the blower motor. Installa ...